Post by MX588 on Sept 11, 2005 20:13:06 GMT -5
This week we are going to talk about how to get your stress marked plastics looking good again without having to buy new ones.
You will need...
[glow=red,2,300]A Heat Gun[/glow]
Towel
Steps
1.Grab your heat gun and towel and go to lets say your back fender for example. put the towel underneath the fender in the spot your going to put heat on.
2. Then turn the heat gun on a low setting and wave it back and forth and you will slowly see the stress mark dissapear.
3. The towel is used to absorb some of the heat so the plastic has a less likely chance of melting incase you get a little crazy with the heat. Once the stress mark is gone go onto the next one if you have more.
You will need...
[glow=red,2,300]A Heat Gun[/glow]
Towel
Steps
1.Grab your heat gun and towel and go to lets say your back fender for example. put the towel underneath the fender in the spot your going to put heat on.
2. Then turn the heat gun on a low setting and wave it back and forth and you will slowly see the stress mark dissapear.
3. The towel is used to absorb some of the heat so the plastic has a less likely chance of melting incase you get a little crazy with the heat. Once the stress mark is gone go onto the next one if you have more.
