|
|
Post by troy on Jul 7, 2005 23:27:04 GMT -5
ok i got a 94 yz125. I have a bad bogg of the idle. ive tried many different jets. Ive tried alot of things. No luck. i replaced the driveside crank seal cause it was leeking a lil bit. But still no luck. ANy suggestion. reeds r fine.
|
|
|
|
Post by punkrawkrider on Jul 7, 2005 23:46:09 GMT -5
sounds to me like you need to rebuild your carbueretor since being as this is an old bike, it maybe hasnt been cleaned or has been a while since it has.....just spend the relatively small amount to rebuild the carb and that should keep the bike happy for a long time....also when rebuilding the carb and starting it again, use plain fuel ONLY no additives, a lot of people think that the additives like the carb cleaners and stuff in your gas help...but a lot of the time for getting it running again you are better off with just plain gas and make it fresh right out of the pmp too, and dont forget to change the oil while youre at the carb
do this first, and then tell me what happens, and hopefully that should clear everything up for you
cam
|
|
|
|
Post by greasemonkey on Jul 7, 2005 23:46:49 GMT -5
youve already talked to 2 of us on this site... i knwo you talked to me and brian tonite about it.. btw did he help you better than i did?  if so what was the problem? |
|
|
|
Post by MX588 on Jul 8, 2005 12:29:10 GMT -5
My guess is it could be the needle and seat, or possibly when you were tweeking with it you messed up the float, there are so many things that can go wrong with a bike that you just have to take the time to find whats wrong.
|
|
|
|
Post by troy on Jul 8, 2005 13:37:33 GMT -5
how much is it for a carb rebuild kit? i checked the float. it is fine.
|
|
|
|
Post by MX588 on Jul 8, 2005 15:18:49 GMT -5
I couldnt tell ya offhand, but a new carb is like $300 or so the last time i looked. You will probably have to get the parts or whatever you need through your dealer i bet.
|
|
|
|
Post by troy on Jul 8, 2005 19:18:31 GMT -5
no theres this place near me called sudco. they sell the carbs there and all the parts u can possibly need. there like 1/5 the price of the dealer. what would i have to get new.
|
|
|
|
Post by punkrawkrider on Jul 23, 2005 16:46:52 GMT -5
if i was you i would spend the money to get the quality stuff....a rebuild kit could run you anywhere from $20-50 on most of the engines we rebuild a full rebuild kit is around $34.
|
|
if so what was the problem?
