|
|
Post by Erik420 on May 21, 2005 15:36:01 GMT -5
well went out in my garage today and wanted to ride the yz around for a little bit. so i kick it over starts first kick and then i squezze in my clutch and then i put it in gear and it dies. it was like if u dont sqezze in ur clutch and u push down the shifter it will die right away correct. this is what it was like but i squeezed in my clutch. i was just wondering if any of you would know what the problem is at alll thanks.
|
|
|
|
Post by travis215 on May 22, 2005 10:54:30 GMT -5
try reving it a little bit and if wants to take off when u put it in gear ur plates arnt disengaging.
I would check my slack and if that don't work your clutch basket is prolly notched and wont let the plates spread apart.
|
|
|
|
Post by Erik420 on May 22, 2005 17:28:15 GMT -5
ya i reved it and i squeezed the clutch in and out and it did nuthin im thinking of goign with a EBC or GYT-R clutch kit. do you know which is better.
|
|
|
|
Post by MX588 on May 22, 2005 17:29:26 GMT -5
yeah it sounds like something to do with your clutch plates and/or your clutch basket is trashed, same thing happened to my cousins CR250 that he used to have.
|
|
|
|
Post by MX588 on May 22, 2005 20:49:29 GMT -5
actually Hinson makes really good clutch components...like all the pro's use Hinson stuff.
|
|
|
|
Post by TenEightySalomon on May 30, 2005 22:26:34 GMT -5
ya i reved it and i squeezed the clutch in and out and it did nuthin im thinking of goign with a EBC or GYT-R clutch kit. do you know which is better. Tear all the components out, measure them and compare vs. the specified limits. For clutch components I trust Hinson VERY much! |
|
|
|
Post by yzdirtrider13 on Aug 17, 2005 23:33:19 GMT -5
yeah they are they way to go
|
|
